ACRYLAN THERMO-BLOCK White 3 L

Innovative water insulating and thermoprotective, high reflective paint, based on special pure acrylic UV-crosslinking elastic resins and new technology reflecting and heat insulating micro spheres. It provides an excellent finish and exhibits great protection to temperature variations and water insulation and exceptional weather fastness, even if exposed to adverse weather conditions or pollutants in a seaside or industrial environment. The product offers energy savings due to decreased use of cooling and heating devices and simultaneously contributes to dealing with the urban heat island phenomenon and global climate change caused by global warming. Acrylan Thermo-Block is certified from the University of Athens, department of Physics as a cool paint characterized by high solar reflectance value (SR), high infrared emittance (ε) and high reflectance index value (SRI). • Certified cool paint with special 100% acrylic UV-crosslinking resins and heat insulating micro beads • High reflectivity for energy saving • Excellent performance & durability under extreme weather conditions • Specially enhanced high durability (HD) shades for optimum resistance to UV radiation According to the official measurements carried out by the Centre for Renewable Energy Sources and Saving (C.R.E.S.), this product achieves extremely low thermal conductivity coefficient λ (λsp thermo) = 0,1317 W/(m.K)(ELOT ΕΝ 12667). COLOURS White and a wide range of light cool shades through Vitex Coloring System. For this reason only high weather fastness and solar reflective colorants are utilized, whilst all the shades are chosen in that way that they all can achieve high reflecting properties.SURFACE PREPARATION Surfaces should be smooth, clean and dry, free from grease, dust, loose or flaking paint. Acrylan Thermoblock is directly applied on already painted surfaces as long as the old paint is sound. To fill any cracks or holes use Acrylic Putty. Old surfaces should be primed, on a case by case basis, with Vitosin, Durovit or Acrylan Unco Eco. New surfaces made of plaster, concrete, cement, plasterboard, etc. should be first primed with Acrylan Unco Eco. APPLICATION Stir well before use. Apply two or more coats by roller, brush or airless spray gun diluted up to 10% with water for the first coat and without dilution for the second one. Do not apply at temperature below 5°C, above 35°C and / or relative humidity above 70%. Avoid application when rain or frost is expected in the next 48 hours. It is touch-dry after 2-3 hours and can be recoated after 6-8 hours. Drying time depends on weather conditions (humidity and temperature). Tools must be cleaned immediately after use with water and if needed with soapy water or a detergent.